Wood flooring installation

1, when installing the floor to keep the ground dry, smooth, clean. Hollow Core Ultra Deck The key to particularly dry impatient. If you do not install the keel, the laying of the ground should also be absolutely flat. Also laying the floor the same day, other workers at home should be temporary exit.
2, the floor to, you must open package inspection, to confirm the floor is ordered to send their own models. It is best to open the package to see the floor, check for quality problems. Carefully compare the color difference is not big, although the floor will inevitably have some color, but if the color is too large, feel unacceptable, can be rejected, and timely contact with the sales side, as soon as possible. Do not wait for the floor shop finished, only to find color, this time will cause a loss. And the general flooring vendors in the floor will be sent to you in the receipt of a single signature, once you sign, it means the quality of the floor recognized.
3, because the laying of the floor, the home has been basically completed, so there are workers to the scene when workers should be reminded to avoid knocking finished products have been completed. Workers in playing skirting board, the door of the installation of the pressure of the eye, saw the lower end of the door sets, it is necessary to clearly tell the workers, where can not drill, not sawing, so as not to undermine the original water pipe and pipe. This is very critical, many owners have encountered a nail skirting board to penetrate the water pipe of the situation.
4, before construction,Rubber Surfacing for Pool Decks the need to re-verify with the workers a pre-determined orientation and methods of laying. In addition to open a few packs of flooring, and workers - from the floor to see the color texture changes to determine the random laying, or sub-depth, color and then laying. You can put some color is not very beautiful floor laying to the cloakroom, bed and other large pieces of furniture below. I laying the floor when the floor is also a number of horizontal texture of the floor selected to shop in the aisle, paved after looks very chic, there are features.
5, the door under the mouth and the floor (including the thickness of the entrance layering) after the laying of the spacing to be maintained at 4 mm or more, to prevent the door after the sun sink, affecting the opening and closing.
6, the best in the balcony sawing the floor, bathroom or corridor operation.
7, between the floor and the wall to ensure that the expansion joints 8-10 mm,Non Slip Products for Composite Decking otherwise the floor will lose the flexibility of the room, easy to arch. General floor thickness of 8 mm or more, you can cut a thickness of 8-10 mm of wood, as the wedge pressure in the wall expansion joints as a measure of the standard. When installing the skirting board, be sure to remove the wedge in the expansion joint, otherwise the expansion joint will remain white. Installation of the baseboard should completely cover the expansion joints. In order to firmly install the baseboard, it is best to use a nail nail. After installation, please ask the oil workers to repair nails and seams. Skirting angle of yin and yang should be 45 degrees diagonal way, will be a lot of beautiful.
8, the ground layer of moisture, geothermal floor laying between the plastic sheeting, the interface must be a good lap, and adhesive tape.
9, if the laying of the floor length or width of more than 8 meters, Capped Composite Deck Boards room, hall between the interface or the door, you must install the layering.